Publicidad
Idiomas disponibles
Idiomas disponibles
Property damage, bodily harm, severe burns, and death could result from failure to follow these
safety steps. These steps should be performed after the grill has been assembled and prior to
each use. DO NOT operate this grill until you have read and understand ALL of the warnings and
instructions in this manual.
•
Ensure that the grill is properly assembled.
•
Inspect the gas supply hose for burns, chaffing, kinks, and proper routing before each use. If it is
evident there is excessive abrasion or wear, or the hose is cut, it must be replaced prior to the grill
being used. Replace with hose and regulator Model No. 155-6420-0, which can be obtained by
contacting customer service at 800-527-0717.
•
Leak check all gas connections, hose and propane tank. See section on "Leak Testing".
•
Ensure that all electrical supply cords are properly grounded. Keep any electrical supply cord and the
fuel supply hose away from any heated surfaces. Hose should be at least 3 inches from hot surfaces.
•
Position your grill on a non-combustible level surface in a well ventilated location, a safe distance
10 ft. (3.1 m) from combustible materials, buildings and overhangs.
•
Properly place the empty grease cup under the grease drain hole in the bottom of the grill to catch
grease during use.
•
DO NOT block ventilation areas in sides, back or cart compartment of grill.
Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any
of the warnings and instructions contained in the preceding sections of this manual.
Follow the instructions exactly.
1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside
the grill. An explosion could occur if grill lid is down.
2. Check that all burner control knobs and the cylinder valve are turned to the "OFF" position.
3. Turn on the fuel supply by slowly rotating the cylinder valve knob counter-clockwise to full open.
4. DO NOT stand with head, body, or arms over the grill when lighting.
LIGHTING THE MAIN BURNERS:
1. Open lid before lighting burner.
2. Make sure all control knobs are in the "OFF" position.
3. Push and hold down the IGNITION BURNER control knob and turn SLOWLY
(2 to 3 seconds) to "HIGH". You should hear the igniter click.
Note:
Step 3 may need to be repeated 2-3 times to light grill.
4. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5
minutes to allow gas to dissipate and repeat lighting procedure.
5. To light other burners, push and turn control knobs to "HIGH" in sequence from
right to left.
9
All manuals and user guides at all-guides.com
PRE-START CHECK LIST:
DANGER
LIGHTING INSTRUCTIONS:
WARNING
Publicidad
