Minuteman ROS 17 ORB 115V Manual De Uso Y Mantenimiento página 38

10
10
1. Insert the detergent solution pipe (7) into the hole in the solution tank (
2.
3. Insert the solution tank cap (4) (
7
13
CHECKING AND CLEANING THE DETERGENT SOLUTION DRAUGHT FILTER
1. Take the device to the dedicated maintenance area.
ATTENTION: the place designated for this operation must comply with current environmental protection regulations.
2. Check that the plug (1) on the power cable (2) has been taken out of the socket (3) of the mains supply(
ATTENTION: these operations must be carried out using protective gloves to avoid any possible contact with the edges or tips of metal objects.
ATTENTION: To prevent damaging the power cable, disconnect the plug from the mains socket by directly pulling the plug and not the cable.
3. Make sure the solution tank is empty, otherwise empty it completely.
4. Remove the solution tank cap (4) (
5. Disconnect the detergent solution pipe (5) from the quick coupling (6) (
ATTENTION: users are advised to always wear protective gloves, to avoid the risk of serious injury to hands.
6.
7. Repeat the operations in reverse order to reassemble all the parts.
1
CHECKING AND CLEANING THE DETERGENT SOLUTION SPRAY NOZZLE
To clean the detergent solution spray nozzle proceed as follows:
1. Take the device to the dedicated maintenance area.
ATTENTION: the place designated for this operation must comply with current environmental protection regulations.
2. Check that the plug (1) on the power cable (2) has been taken out of the socket (3) of the mains supply(
ATTENTION: these operations must be carried out using protective gloves to avoid any possible contact with the edges or tips of metal objects.
ATTENTION: To prevent damaging the power cable, disconnect the plug from the mains socket by directly pulling the plug and not the cable.
3. Make sure the solution tank is empty, otherwise empty it completely.
5
6
11
).
7
14
).
3
5
1
6
2
4
2
35 35
9
12
).
). Make sure that the
4
15
), and if not, disconnect it.
).
3
), and if not, disconnect it.