At The End Of The Work - Minuteman ROS 17 ORB 115V Manual De Uso Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. If you intend to use the spray system, operate the lever of pump control switch (8) on the control
handlebar.
ATTENTION: Pushing the lever (8) forwards starts the pump in intermittent mode (Fig.7).
ATTENTION: Pushing the lever (8) backward starts the pump in continuous mode.
2. Push the machine with the brush rotating from left to right or vice versa.
3. Immediately afterwards, push the machine in the same way but in the opposite direction, so that
about one quarter of the working width overlaps the previous one.
4. We recommend that you vacuum up the dirt-loaded foam at intervals with the aid of a vacuum cleaner
for liquids (optional solution tank kit).
ATTENTION:
movement of the machine, and should therefore not operate the machine near people or
obstacles.
ATTENTION: Work in slow movements to the right and left, possibly moving back so that the
ATTENTION: Keep the power supply cable behind the operator, taking care not to operate the
machine in its vicinity in order not to damage it.
ATTENTION:
ATTENTION: If you need to work in tight spaces you can turn the control column to the vertical
position.
7
At the end of the work, and before carrying out any type of
maintenance, perform the following operations:
1. Disconnect the plug (1) of the power supply cable (2) in the mains
supply socket (3) (
).
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
1
ATTENTION: During this operation, do not rest your foot on
the appliance.
3. Tip the appliance back and take it to the maintenance
area and carry out all the procedures listed in the section
"RECOMMENDED PERIODIC
MAINTENANCE" indicated in the
column "AT THE END OF THE WORK".

AT THE END OF THE WORK

ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
2. Turn the handlebar to the vertical position, press the uncoupling
lever (4) (
(
). When the handlebar is vertical, release the uncoupling
lever (4).
3
1
2
2
4.
designated machine storage place.
ATTENTION: Park the appliance in an enclosed place, on a
could either damage it, or be damaged through contact with it.
32
32
) and turn the handlebar to the vertical position
4
3

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido