Preparation Of The Appliance; Inserting The Brush; Inserting The Solution Tank (Optional) - Minuteman ROS 17 ORB 115V Manual De Uso Y Mantenimiento

To insert the brush/pad holder into the brush head body of the
appliance, proceed as follows:
1. Check that the plug (1) on the power cable (2) has been taken
out of the socket (3) of the mains supply (
disconnect it.
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
1
3. Tip the appliance back ( ), block one of the rear wheels and
shift the control column backwards.
4.
4
To insert the solution tank onto the handlebars, proceed as follows:
1. Secure the handlebar in a position at about 45° with respect to
the ground ( ).
1
3. Put the solution tank on the column, so that the bottom of the tank
4. Holding the tank with one hand, move the mobile bracket (3)
down until the solution tank is locked to the column (

PREPARATION OF THE APPLIANCE

INSERTING THE BRUSH

ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
), and if not, 2. Check that the handlebar is in the vertical position, if not, press
the uncoupling lever (4) (
vertical position (
the uncoupling lever (4).
3
1
2
2
5. Turn the brush anti-clockwise to secure it to the
hub (
center the fastening pins on the machine with the
).
drive holes. Then insert the centering plate and
5
INSERTING THE SOLUTION TANK
2. Unscrewing the closing knob (1) (
brackets beyond half of the column (
been positioned).
1
2
5. Lock the position of the mobile bracket (3) by tightening the
). closing knob (1) (
6. Insert the water distribution pipe (4) in the hole on the brush head
). (5) (
29 29
) and turn the handlebar to the
). When the handlebar is vertical, release
4
3
). Insert the drive disc, be careful to
6
) position the upper
) (if it has not already
3
).
).