TYPE OF MAINTENANCE
Checking and cleaning the pad holder
Checking and cleaning the solution tank
Checking and cleaning the detergent solution spray nozzle
as well as a longer brush motor life. To clean the pad holder, proceed
as follows:
1. Take the appliance to the dedicated dirty water drainage area.
ATTENTION: The place this operation is carried out should
comply with current environmental protection regulations.
1
3. Check that the handlebar is in the vertical position, if not, press
the uncoupling lever (4) (
) and turn the handlebar to the
vertical position (
). When the handlebar is vertical, release
the uncoupling lever (4).
4. Tip the appliance back (
), block one of the rear wheels and
shift the control column backwards.
5.
(
4
MAINTENANCE
RECOMMENDED MAINTENANCE OPERATIONS
CONTROL AND CLEANING OF THE BRUSH
2. Check that the plug (1) on the power cable (2) has been taken out
of the socket (3) of the mains supply(
it.
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
3
1
2
2
6. Remove the brush from the appliance (
7. Clean the brush/pad holder under running water and remove any
impurities present in the bristles of the brush or on the surface of
the Check the bristles. If they are excessively worn, replace the
brush (the bristles should protrude by at least 10mm).
8. Repeat the operations in reverse order to reassemble all the
parts.
).
5
33
33
X
X
X
X
X
X
X
X
X
X
), and if not, disconnect
4
3
).