Disposal; Troubleshooting - Minuteman ROS 17 ORB 115V Manual De Uso Y Mantenimiento

4.
5. Remove the spray nozzle (5), being careful not to lose the washer (6) (
ATTENTION: users are advised to always wear protective gloves, to avoid the risk of serious injury to hands.
6. Clean the nozzle under a jet of running water, if necessary remove any impurities.
7. Repeat the operations in reverse order to reassemble all the parts.
1
To dispose of the appliance, take it to a demolition centre or an
authorised collection centre.
Before scrapping the appliance, it is necessary to remove and
separate out the following materials, then send them to the
appropriate collection centres in accordance with applicable
environmental hygiene regulations:
• Pad holders or brushes
• Electric and electronic parts*
• Plastic parts
• Metallic parts
(*) In particular, contact your distributor when scrapping electric and
electronic parts.
This chapter lists the most common problems linked with the use of the appliance. If you are unable to resolve the problems with the
information given here, please contact your nearest assistance centre.
PROBLEM
THE APPLIANCE DOES NOT SWITCH ON
INSUFFICIENT DETERGENT SOLUTION
ON THE PAD HOLDER
).
).
3 5
1 6
2
4
2

DISPOSAL

TROUBLESHOOTING

POSSIBLE CAUSE
The power cable extension is not connected
to the mains socket.
The power cable extension is not connected
to the appliance's power cable.
should correspond to the electrical
Extension cable damaged.
Overheating of the brush head motor.
The amount of detergent in the solution tank
36 36
3
SOLUTION
Check that the plug on the extension cable
has been inserted into the mains supply
socket.
Check that the plug on the cable of the
appliance has been inserted into the socket
on the extension cable.
of the appliance correspond to the electrical
check the technical information on the serial
number plate.
Check the extension cable is not damaged,
and if it is, replace it.
Make sure that the thermal breaker on the
back of the handlebar has not tripped. If it
has, wait a few minutes until it has cooled
button to reactivate the power supply and
motor operation
Make sure that the amount of detergent
the work to be carried out, and if necessary