Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
INSTALLING THE RANGE HOOD
- Lift the range hood (A) up under the cabinet to determine its final
position . Mark the location of the four keyhole mounting slots (1) on
the underside of the cabinet .
- Set the range hood (A) aside on a protective surface .
- Drill four pilot holes in the locations that you marked .
- Screw the four long tapping screws (AA) into the pilot holes . Do not
tighten the screws all the way – leave the screw heads about 0.28
in . (7 mm) from the cabinet surface .
- Lift the range hood (A) into position, feeding the power cable and
the electrical wires through the power access opening . Allow some
slack in the cable and wires so that the appliance can be moved if
servicing is ever necessary .
- Position the range hood (A) so the large end (2) of the keyhole
mounting slots (1) are over the screws (AA) . Then push the range
hood (A) toward the wall so the screws (AA) are in the neck (3) of
the keyhole slots . Tighten the screws (AA) . Ensure that the range
hood (A) is securely fastened to the cabinet before releasing it .
- If applicable, test the damper blade to ensure it rotates up and down
freely .
- If applicable, connect the duct work to the range hood (A) . Seal the
joints with duct tape to ensure an airtight fit.
- Reconnect the power supply cable and wires to the electrical
supply . Turn the power on and ensure that the lights and fan are
operating correctly .
Operation
NOTE:
The fan and lights operate independently of each other.
TURNING ON/OFF THE UNIT
- To turn on the fan, press the appropriate speed control
switch [Low Speed (2), Medium Speed (3), High Speed (4)]
to select the desired level of power . Once a button is
pressed, the previous speed mode will be cancelled .
- Press the power switch (1) to turn off the fan .
1
QR065
2
3
12
DANGER: Turn off the power circuit breaker or the
power switch on the junction box before installing this
unit . Touching circuitry inside the range hood while it is
energized will result in death or serious injury .
DANGER: If installing this unit over a gas range, turn off
the gas at the source before installing or servicing this unit .
AA
1
A
TURNING ON/OFF THE LIGHTS
- Press the light switch (5) to turn on and off the lights .
4
AA
1
AA
2
1
3
5
Publicidad
