Connecting The Water Supply - Stihl RB 200 Manual De Instrucciones

English
Connection to the spray gun
Connecting
1
2
Push the high-pressure hose into
N
the coupling on the spray gun (1)
Attach the union nut (2) and screw it
N
on and tighten by hand
Removing
Unscrew the union nut
N
Pull the high-pressure hose off the
N
coupling on the spray gun
14

Connecting the Water Supply

The pressure washer is equipped with a
thermal pressure relief valve, which
automatically lets hot water escape from
the high-pressure pump. Never use
water with a temperature more then
52 °C (125 °F) to run the pressure
washer. See the "Working" Chapter in
this manual for more information to the
thermal pressure relief valve.
Always comply with the water supply
requirements in the "Specifications"
chapter in this manual.
NOTICE
Insufficient water supply can damage
the high-pressure pump. Only start the
engine when the water hose is
connected and the water supply is
turned on and delivering the minimum
water requirements in the
"Specifications" chapter in this manual.
Connecting the water hose
Remove all sand and debris from
N
the connections
Connect the water hose to the water
N
supply
Open the water tap and rinse the
N
water hose so that sand and other
particles of dirt cannot get into the
high-pressure pump
2
1
Turn off the water supply and
N
connect the water hose (1) to the
high-pressure pump (2)
Venting the system
Before starting the engine, the high-
pressure pump and hose system must
be vented:
After connecting the water supply
N
and high pressure hose to the
pressure washer, unroll the high-
pressure hose fully and lay it out flat
and free from loops
Turn on the water supply
N
Point the spray attachment (without
N
the high-pressure nozzle installed)
downward to the ground
RB 200