Publicidad
Idiomas disponibles
Idiomas disponibles
Model DSN30
4.
KEYS STATEMENT
1.
Calibration: for single-point and multi-point calibration
2.
Unit: for multiple units selection
3.
Count: for simple count
4.
Tare: for deduction of the tare
5.
Clear: for clearing the input figure, accumulation and alarm records
6.
Accumulation: for accumulating the total weight.
7.
Zero: for clearing the slight weight to zero
8.
Backlight: for conversion between the no backlight and backlight.
9.
Confirm: for conforming the set value.
10.
Print: for printing
11.
Alarm preset: for set the weight in a certain range to alarm
12.
Increase by degree: 0-9 progressively increasing keys.
13.
Leftward: moving to the left
14.
Rightward: moving to the right
5. OPERATION
HORIZONTAL ADJUSTMENT
The level of the scale should be checked firstly. Adjust the four feet to center the bubble on the scale.
WEIGHING
Turn the scale on. The display screen will show number 0 after self-testing. Put the commodity on the scale, and the display will show
its weight and a stable signal"o".
ZERO
When no product or slight weight on the scale, you can press
TARE
Place the commodity needed deducting the tare on the scale and then press the
of the product.
TARE PRESET
If knowing the tare of the product in advance, press the key
and then 000000. And then press keys
that, the display shows the negative pre-deducted value. At this time, the machine will automatically deduct the tare. Pressing
again can clear the preset tare.
Eg: suppose pre-deducted weight is 1200g, at this moment, the display shows 00000"0"g.
Press the "leftward" for four times and the display shows 00"0"000g.
Press the "accumulation" once and the display shows 00"1"000g.
Press the "rightward" once and the display shows 001"0"00g.
Press the "accumulation" twice and the display shows 001"2"00g.
COUNT
Place the sample product at the number of ten, or twenty, or fifty, or hundred on the scale. Press
ose the corresponding C00010 C00020 C00050 or C00100. Then you can put the product for counting. For back out from the counting
mode, press the
nonstoply.
ACCUMULATION
In the weighing mode, after the machine's stable, press the
lated times and then the accumulating total weight. In the zero point, pressing the
display of accumulating contents; you can clear the accumulated records by pressing
Top loading scale
,
and
to input the known product value. Then press
back to zero.
. After that, the weight illustrated is the net weight
for a long time until the display shows preset information "PrE" first
for weight accumulation. The display screen first shows the accumu-
can read the accumulating contents. During the
.
User's Guide
for confirmation. After
after the machine's stable to cho-
15
Publicidad
