Publicidad
Idiomas disponibles
Idiomas disponibles
Model DSN30
3-8 is weighing zone, indicating the weight figure under the current unit, the higher digit should be in the front.
10 is the unit zone, but it may be different from which is shown on the screen.
Output pins: pin1 GND pin2 TXD pin3 RXD
Below is the table:
7. MENU SET
Press
to enter Menu set. The display firstly shows the zero tracing set information and then zero tracing value. Press
choose the desire zero tracing value: 0d,1d, 2d, 3d. press
to the original after finishing set.
The detailed sets are as below:
Serial number
Display
1
Zero:
Zero tracing
2
DFLOU:
Dynamic tracing
3
D-rng:
Dynamatic diagnostic
PointD:
4
Average value filter
FILtEr:
5
wind-resistance and shock-
resistance filter
Spnt:
6
Calibration mode
SPEED:
7
Sample speed
Top loading scale
Display
g
ct
dwt
oz
kg
Pb
Set value
0.5d
1d
2d
1
4
6
8
10
0.5d
1d
2d
4
8
16
0
1
2
3
0
1
0
1
The tenth byte output
g(small letter)
c(small letter)
d(small letter)
o(small letter)
for confirmation to enter the next set .the scale will automatically back
Set introduction
Tout au plus haut c'est la valeur de recherche, plus rapidement
celui-ci retournera à zéro.
Suitable for powder and liquid products
Suitable for the sheet ,nubby and granular products
The higher the dynamic diagnostic value is, the more stable
the balance is. But the resolution becomes bad, so it is better
to use in a worse environment.
The higher the filter point is, the more stable the scale is.
But It responds slowly.
The higher the value is, the more stable the balance is. It is
suitable for using under the worse environment and unsuitable
for the powder products.
Single point calibration mode
Multipoints calibration mode
Fast sampling
Factory set
User's Guide
to
17
Publicidad
