Mounting The Loop Handle; Adjusting The Throttle Cable - Stihl FS 100 RX Manual De Instrucciones

STIHL SuperCut mowing head
Fresh line is advanced automatically.
Frayed line is replaced by a simple
adjustment (see instruction sheet
supplied with mowing head).
STIHL AutoCut mowing head
Nylon cutting cord advances
automatically when tapped against the
ground.
STIHL TrimCut mowing head
Frayed line is replaced by a simple
adjustment (see instruction sheet
supplied with mowing head).
FS 100 RX

Mounting the Loop Handle

: Secure the loop handle (1)
approx. 8" (20cm) (A) forward of
the control handle (2).
: Line up the loop handle.
: Tighten down the screws.
Sleeve (3)
English / USA

Adjusting the Throttle Cable

A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled – the
control handle must be in the normal
operating position.
: Use a suitable tool to push the slide
to the bottom of the slot (see
illustration).
13