Stopping The Engine - Stihl FS 100 RX Manual De Instrucciones

English / USA
: Crank engine until it begins to fire.
After no more than five attempts,
turn the choke knob to e
: continue cranking.
When the engine begins to fire:
: Blip the throttle trigger so that the
slide control moves to the normal
run position # and the engine settles
down to idle speed.
Make sure the carburetor is
correctly adjusted – the cutting tool
must not rotate when the engine is
idling.
Your machine is now ready for
operation.

Stopping the engine

: Move the slide control in direction of
arrow (h) to STOP-O.
At very low outside temperatures
As soon as engine runs:
: Blip the throttle trigger to disengage
the starting throttle position. The
slide control moves to the normal
run position #
and the engine settles down to idle
speed.
: Open the throttle slightly.
: Warm up engine for brief period.
22
If the engine does not start
Choke knob
If you did not turn the choke knob to e
quickly enough after the engine began to
fire, the combustion chamber has
flooded.
Turn choke knob to e
:
: Select starting throttle position.
: Start the engine by pulling the
starter rope firmly. 10 to 20 pulls
may be necessary.
If the engine still does not start:
10
: Move the slide control to STOP-O.
: Pull off the spark plug boot (10).
: Unscrew and dry off the spark plug.
: Open the throttle wide.
: Crank the engine several times with
the starter to clear the combustion
chamber.
: Refit the spark plug. Connect the
spark plug boot (press it down
firmly).
: Move the slide control to START.
: Set the choke knob to e –
even if engine is cold.
: Now start the engine.
Throttle cable adjustment
: Check adjustment of throttle cable –
see "Adjusting the Throttle Cable".
Tank run until dry
: After refueling, press the fuel pump
bulb at least five times – even if bulb
is filled with fuel.
: Set choke knob according to engine
temperature.
: Now start the engine.
FS 100 RX