Cleaning And Maintenance; Transport And Storage - Platinum PRO Air Bike Manual Del Usuario

English
Warranty limitations
This warranty covers manufacturing defects in the
fitness equipment as originally packed by Tunturi
New Fitness BV. The warranty shall apply only under
conditions of normal, recommended use of the product
as described in the Owner's Manual and providing that
Tunturi New Fitness BV's instructions for installation,
maintenance and use have been complied with. Neither
Tunturi New Fitness BV's nor the Tunturi Distributors'
obligations apply to defects due to reasons beyond
their control. The warranty applies only to the original
purchaser and is valid only in countries where Tunturi
New Fitness BV has an authorised importer. The
warranty does not extend to fitness equipment or
components that have been modified without the
consent of Tunturi New Fitness BV. Defects resulting
from normal wear, misuse, abuse, corrosion, or damage
incurred during loading or transportation are not
covered.
The warranty does not cover sounds or noises emitted
during use where these do not substantially impede the
use of the equipment and where they are not caused by
a fault in the equipment.
The warranty does not cover defects arising from the
failure to carry periodic maintenance as outlined within
the Owner's Manual for the product. Furthermore, the
warranty does not cover defects arising from usage and
storage within an unsuitable environment as described
within the Owner's Manual which should be indoors,
dry, dust and grit free and within a temperature range
of +15°C to +35°C. The warranty does not cover
maintenance activities, such as cleaning, lubricating,
and normal part adjustments, nor installation
procedures that customers can accomplish themselves,
such as changing uncomplicated meters, pedals and
other similar parts not requiring any dismantling/
reassembling of the fitness equipment. Warranty
repairs carried out by other than authorised Tunturi
representatives are not covered.
Failure to follow the instructions given in the Owner's
Manual will invalidate the product's warranty.

Cleaning and maintenance

The equipment does not require special maintenance.
The equipment does not require recalibration when
it is assembled, used and serviced according to the
instructions.
WARNING
• Do not use solvents to clean the equipment.
• Clean the equipment with a soft, absorbent cloth
after each use.
• Regularly check that all screws and nuts
are tight.
• If necessary, lubricate the joints.
Replacing the batteries (fig. F)
The console is equipped with 2 AA batteries at the rear
of the console.
- Remove the cover.
- Remove the old batteries.
- Insert the new batteries. Make sure that batteries
match the (+) and (-) polarity markings.
- Mount the cover.
Troubleshooting
Despite continuous quality control, defects and
malfunctions caused by individual components may
occur in the equipment. In most cases it's unnecessary
to take the whole device in for repair, as it's usually
sufficient to replace the defective part.
If the equipment does not function properly during use,
contact your Tunturi dealer immediately. Always give
the model and serial number of your equipment. Please
state also the nature of the problem, conditions of use
and purchase date.
If you require spare parts, always give the model, serial
number of your equipment and the spare part number
for the part you need. The spare part list is at the back
of this manual. Use only spare parts mentioned in the
spare part list.

Transport and storage

WARNING
• Carry and move the equipment with at least two
persons.
• Remain standing in front of the equipment
on each side and take a sturdy grip at the
handlebars. Tilt the front of the equipment
so as to lift the rear of the equipment on the
wheels. Move the equipment and carefully put
the equipment down. Place the equipment on a
protective base to prevent damage to the floor
surface.
• Move the equipment carefully over uneven
surfaces. Do not move the equipment upstairs
using the wheels, but carry the equipment by the
handlebars.
• Store the equipment in a dry place with as little
temperature variation as possible.
2 4