HTW A3 Serie Manual De Usuario E Instalacion página 45

After child lock is turned on, all button operations except child lock buttons cannot be operated.
Note: After the operation is completed 10S, all lights (including double 8) are all dimmed.
Function Description：
1、Humidity automatic control operation function：
A、When "CO" (continuous) operation is set to dehumidify, the dehumidifier will continue to operate
regardless of the humidity level.
B、If the indoor humidity is higher than or equal to 3% or more of the set humidity, the compressor
and fan will run. The indicator light of the compressor will be on.
C、After the humidity in the room is dehumidified, when the humidity drops below 2% of the set
humidity, the compressor is turned off and the dehumidification is stopped. The indicator lamp (OK
lamp) that reaches the humidity is on.
D、If the dehumidifier stops dehumidifying and the humidity in the room rises above or equal to 3%
or more of the set humidity, if the compressor has passed the three-minute protection status, the
compressor will start dehumidifying.
E、According to the above cycle operation, the indoor humidity can be maintained at the set
humidity.
2、Comfort (shows "AU") function：
A、Below 5°C at room temperature, the dehumidifier stops；
B、5 °C ≤ room temperature ≤ 20 °C, automatic selection set 60% humidity；
C、20°C<room temperature ≤27°C, automatically select setting 55% humidity；
D、Room temperature> 27 °C, automatic selection set 50% humidity.
3、Drying function: (CLOTH light)
A、When this function is enabled, the dehumidifier will continue to operate (compressor, fan
operation) regardless of the humidity level when the "CO" (continuous) operation dehumidifies.
B、The wind speed is locked at high speed and cannot be adjusted.
4、Fan
A、The compressor does not work.
B、The fan can choose two operating modes: high wind and low wind.
C、Humidity setting button cannot be pressed in fan mode
5、Full water protection：
15