1. Limited warranty
Products manufactured by Grundfos Pumps
Corporation (Grundfos) are warranted to the
original user only to be free of defects in material
and workmanship for a period of 24 months from
date of installation, but not more than 30 months
from date of manufacture. Grundfos' liability under
this warranty shall be limited to repairing or
replacing at Grundfos' option, without charge,
F.O.B. Grundfos' factory or authorized service
station, any product of Grundfos manufacture.
Grundfos will not be liable for any costs of
removal, installation, transportation, or any other
charges that may arise in connection with a
warranty claim. Products which are sold, but not
manufactured by Grundfos, are subject to the
warranty provided by the manufacturer of said
products and not by Grundfos' warranty. Grundfos
will not be liable for damage or wear to products
caused by abnormal operating conditions,
accident, abuse, misuse, unauthorized alteration
or repair, or if the product was not installed in
accordance with Grundfos' printed installation and
operating instructions and accepted codes of
good practice. The warranty does not cover
normal wear and tear. To obtain service under this
warranty, the defective product must be returned
to the distributor or dealer of Grundfos' products
from which it was purchased together with proof
of purchase and installation date, failure date and
supporting installation data. Unless otherwise
provided, the distributor or dealer will contact
Grundfos or an authorized service station for
instructions. Any defective product to be returned
to Grundfos or a service station must be sent
freight prepaid; documentation supporting the
warranty claim and/or a Return Material
Authorization must be included if so
instructed. Grundfos will not be liable for any
incidental or consequential damages, losses, or
expenses arising from installation, use, or any
other causes. There are no express or implied
warranties, including merchantability or fitness for
a particular purpose, which extend beyond those
warranties described or referred to above. Some
jurisdictions do not allow the exclusion or
limitation of incidental or consequential damages
and some jurisdictions do not allow limitations on
how long implied warranties may last.
Therefore, the above limitations or exclusions
may not apply to you. This warranty gives you
specific legal rights and you may also have other
rights which vary from jurisdiction to
jurisdiction. Products which are repaired or
replaced by Grundfos or authorized service center
under the provisions of these limited warranty
terms will continue to be covered by Grundfos
warranty only through the remainder of the
original warranty period set forth by the original
purchase date.
2. General information
2.1 Target group
These installation and operating instructions are
intended for professional installers and for the
operators of the product.
We recommend that installation is carried out by
skilled persons with technical qualifications
required by the specific legislation in force.
2.2 Hazard statements
The symbols and hazard statements below may
appear in Grundfos installation and operating
instructions, safety instructions and service
instructions.
DANGER
Indicates a hazardous situation which,
if not avoided, will result in death or se-
rious personal injury.
WARNING
Indicates a hazardous situation which,
if not avoided, could result in death or
serious personal injury.
CAUTION
Indicates a hazardous situation which,
if not avoided, could result in minor or
moderate personal injury.
The hazard statements are structured in the
following way:
SIGNAL WORD
Description of the hazard
Consequence of ignoring the warning
•
Action to avoid the hazard.
2.3 Notes
The symbols and notes below may appear in
Grundfos installation and operating instructions,
safety instructions and service instructions.
Observe these instructions for explo-
FM
sion-proof products.
A blue or gray circle with a white
graphical symbol indicates that an ac-
tion must be taken.
A red or gray circle with a diagonal bar,
possibly with a black graphical symbol,
indicates that an action must not be
taken or must be stopped.
If these instructions are not observed,
it may result in malfunction or damage
to the equipment.
5