TRAPP TR-600 Manual De Instrucciones página 45

www.trapp.com.br
TRAPP shredders, either single-phase or

three-phase, are assembled with dual voltage
motors. They leave factory without electric
wiring so customers can choose the one that
best suits their voltage needs. Follow the
cable connection indication as indicated in
the connection diagram on the engine plate.
For shredders sold without the motor, choose

minimum power according to technical data
under "Technical Characteristics".
For motors of power above 5 cv, the use of a

delta-star switch is recommended. The model
suggested is ETW (WEG Acionamentos) or of
similar type.
As the on/off switch is distant from the

shredder, install an emergency button in the
equipment in case immediate switching off is
necessary.
Supply
Avoid using gasoline stored for more than 7

days, as this causes malfunction decreasing
motor life.
Fill the tank being careful not to spill fuel.

Refuel only with plain (no additives) gasoline.

Installation of Electric Motor
Installation of Gasoline Motor
Attention!
Before making any kind of connection,

be sure the
disconnected.
Make sure the power source where the

shredder will be installed is compatible
with the data on the motor plate.
Make the connections shown according

to the voltage of the power source.
Make sure the rotation direction is

correct and, if necessary, reverse the
rotation direction.
Make sure connections

insulated.
Connect the engine to the mains as

shown in the wiring diagram on the
engine plate.
Note the capacity of the fuel tank, amount

and type crankcase oil (see "Technical Data")
Note: For further information on operation please refer
in the engine manual
power source is
are well
45