TRAPP TR-600 Manual De Instrucciones página 59

www.trapp.com.br
Clean battery and terminals
Corrosion and dirt in battery and terminals can
decrease power.
1. To remove battery from equipment, see item
"Installation" (Check Battery).
2. Wash battery with water and dry it.
3. Clean terminals and cable ends with a metal
brush until shiny.
4. Cover terminals with grease or Vaseline.
5. Install battery.
Gasoline motor
Lubrication
Only use high-quality detergent oil, classified
as SG-SL by API. Select SAE oil, viscosity grade
according to the operation temperature foreseen.
To change motor oil
Establish the temperature range foreseen before
next change of oil. All oils must correspond to API
SG-SL classification.
1. Equipment must be on a flat and level surface.
2. Hot oil will drain better.
3. Collect used oil in proper container.
4. Carefully unscrew oil (3) container to prevent
accidents such as burns.
Image for illustrative purposes only
Attention!
If motor is hot when changing oil, be careful to
remove oil container. Hot oil is released with
more pressure, and may cause burns. Wear
suitable protective eyewear and gloves.
5. When oil has been fully drained, screw back oil
container (3).
6. Remove the cover (1) and fill the sump with oil
with the quantity defined in the motor manual.
After completed, close it again.
7. Check the level of oil with indicating rod (2). For
better reading, firmly hold cover on tube before
removing the rod. Keep oil at rod "Full" level.
Oil drain plug
Image merely illustrative
Note:
Imagem meramente ilustrativa

3
All maintenance or cleaning should be done
with the power off and the spark plug wire
disconnected.
Image for illustrative purposes only
2
Frequently check level of motor oil to
prevent damage due to lack of oil.
Attention!
Oil inlet cap
1
Oil level
inspection
dipstick
59