TRAPP TR-600 Manual De Instrucciones página 53

www.trapp.com.br
When using the equipment
Check if rotation direction is correct.

Only shred wood and plant waste of proper

dimensions.
Wear proper clothes and safety equipment.

Make sure there is enough fuel in the tractor

to prevent an unplanned stop. When using
the TR-600T.
Only use shredder in safe conditions, well lit

and ventilated areas.
Push small material with long pieces of wood.

Small wood fragments must be slowly

pushed, longitudinally, to prevent chips from
being thrown against the operator.
Check whether

connected on the electrical outlet when using
the TR-600T.
The equipment must rest safely on the ground.

To avoid overloading TDP, shredder must be

parallel to the ground.
Blades must be sharp.

Check whether output device is properly

assembled and in the right direction.
Properly secure and adjust counterblade.

Check for the presence of tools or objects on

motor or equipment, mainly inside the funnel.
Check for people, pets or objects near the

area.
Attention!
Unless when maintaining, do not remove

safety devices, protection covers or
collectors. When removal is necessary,
stop the motor, handle carefully and
reassemble properly before using the
equipment again.
To prevent major accidents, do not put

your hand inside the funnel.
Operation Instructions
machine is properly
Notes:
If the equipment is properly prepared,

start the engine. Wait for it to reach
maximum speed and start working.
For diesel or gasoline engines, keep it

running for a few minutes in order to
reach normal operating temperature.
Never start or run a diesel or gasoline

engine indoors or without ventilation.
The exhaust gas contains carbon
monoxide, an odorless and lethal gas.
Turning the shredder on TR-600T
When all preparation steps are done, the machine
will be ready for use.
Tractor discharge power must be 540 rpm.
Connecting the crusher TR-600G
Make sure there is oil in the crankcase and

correct level.
Check for gasoline in the fuel tank.

Set the on and off switch to the "ON" position

and open the fuel valve. Then activate the
choke lever and start the switch or lightly
pull the rewind starter cord until you meet
resistance, then pull it sharply. Repeat this
operation until the engine runs. In the model
with electric starter motor, pulling the rewind
starter cord is not necessary. Check the motor
manual for the proper start-up procedure.
Gently pull the retractable starting cord until

meet resistance, and then pull it sharply.
Repeat until the motor starts.
Let the motor warm up for a few minutes and

return the choke lever to its original position.
Operate the throttle and start working.

To turn off the motor. Turn off the motor

specified key.
Note: For further information on operation please refer
to the engine manual.
53