Brandt BOP2112B Manual De Instrucciones página 111

Caring for and cleaning your appliance
CLEANING THE INNER AND OUTER SURFACES
• Cleaning the oven cavity with pyrolysis
WARNING
Remove the accessories from the oven before beginning pyrolysis cleaning. Before starting
pyrolysis cleaning, remove any large overspills, if any. Remove the excess grease on the door
using a damp sponge.
As a safety measure, cleaning by pyrolysis only occurs after the door locks automatically, it is then impos-
sible to unlock the door.
• Immediate self-cleaning
The programmer must display the time of day and must not be flashing. Select the self-
cleaning cycle with the function selector
depending on the degree of soiling of your oven, and confirm by pressing the knob.
Select between:
At the end of the cleaning cycle, 00:00 will appear on the display and the door will be unlocked. Turn the
function selector back to 0.
* PyroExpress in 59 minutes
= PyroExpress*
This specific function uses the heat built up during a previous cooking cycle to quickly and
automatically clean the inside of the oven: it cleans a mildly dirty oven interior in less than
an hour.
The electronic oven temperature monitor determines whether the residual heat remaining
in the oven interior is sufficient to provide a good cleaning result. If this is not the case, a
90-minute ECO pyrolysis cycle will automatically begin.
• Delayed self-cleaning
You can choose to delay the start of the pyrolysis cycle: When the programme duration displays on the
screen, press the
knob. The self-clean will start later on to end at the new set time. Turn the function selector back to 0 once
the cleaning cycle has ended.
16
= 2-hour pyrolysis cycle, confirm by pressing the knob.
pressing the knob.
key and set the new end time with the + and - knob, then confirm by pressing the
: select your pyrolysis cycle with the + and - knob
= PyroExpress* or ECO Pyrolysis (1H30)* confirm by