Bevel Pivot; Laser Adjustments - Delta ShopMaster S26-262L Manual De Instrucciones

BEVEL PIVOT

With the bevel lock knob loosened, the control arm of the
saw should tilt easily from 0° and 45°. If it does not or if
there is play in the pivot, the saw must be repaired by an
AUTHORIZED SHOPMASTER SERVICE CENTER.

LASER ADJUSTMENTS

This saw is equipped with an adjustable laser which
projects a red line onto the work piece surface, see
Figure 24. Refer to the "Using Your Laser Guide" section
on page 14 for more information on how to operate laser.
This section will instruct you how to adjust the laser
alignment for more accurate cuts.
Laser radiation. Avoid direct eye contact
with light source.
• Avoid direct eye exposure to laser beam or reflection.
Intense or prolonged exposure to laser radiation
could permanently damage your eyes. Do not project
or reflect the laser into anyone's eyes, including your
own.
• Caution -- use of controls or adjustments or
performance of procedures other than those
specified herein may results in hazardous radiation
exposure.
• Use or modification of the laser guide for anything
other than its designed purpose may result in
hazardous radiation exposure.
LASER PARALLEL ADJUSTMENT
If you notice the laser line is not perfectly parallel with
the saw blade refer to Figure 25 and follow these
instructions: using a Phillips head screwdriver turn screw
(A) until the laser line is parallel with the saw blade.
LASER VERTICAL ANGLE
ADJUSTMENT
If you notice the laser line does not remain parallel to the
blade as the saw head is lowered to make a cut refer to
Figure 26 and follow these instructions: using a Phillips
head screwdriver turn the screw (B) to adjust the vertical
angle of the laser.
ADJUSTMENTS
20
FIGURE 24
FIGURE 25
B
FIGURE 26
A