Publicidad
Idiomas disponibles
Idiomas disponibles
Disengage the mowing blade in the
following sequence:
● Drive onto an area of grass which has
already been mown or select the
highest mowing deck cutting level.
(
8.11)
● Disengage the mowing deck by
pressing the mowing deck switch.
(
8.3)
Risk of injury!
After disengaging the mowing deck,
beware of the mowing blade
running on for up to 5 seconds
before coming to a standstill.
(
11.)
12.8 Programming automatic
disengagement of the mowing deck
The electromagnetic blade clutch
can be programmed so that the
mowing deck is automatically
disengaged when the grass catcher box is
full. This enhances operating convenience
as blockage of the discharge chute is
prevented.
● Stop the engine. (
12.3)
● Turn the ignition key to the "ignition on"
position. (
8.1)
● Wait for the electronics self-diagnosis.
Activating automatic disengagement:
● Set the driving direction selector lever
to forwards.
● Press the reverse mowing safety switch
and actuate the drive pedal at the same
time for 5 seconds.
A short beep signals that automatic
operation is switched on.
86
● The current setting is permanently
saved.
Deactivating automatic
disengagement:
● Set the driving direction selector lever
to forwards.
● Press the reverse mowing safety switch
and actuate the drive pedal at the same
time for 5 seconds.
Three beeps in quick succession signal
that automatic operation is switched off.
● The current setting is permanently
saved.
12.9 Emptying the grass catcher box
Risk of injury:
Only empty the grass catcher box
on level surfaces, as the centre of
gravity is changed by swinging up
the grass catcher box and thus the
danger of tipping over is increased.
A permanent continuous tone
during mowing signals that the
grass catcher box is completely full
and must be emptied.
Disengage the mowing deck. The
continuous tone ceases once the
mowing deck has been
disengaged.
Grass catcher box not being
completely filled
● Check whether the discharge chute is
installed. (
14.6)
● Correctly adjust the level sensor (grass
catcher box). (
8.15)
● When emptying the grass catcher box,
check the discharge chute for blockage
and clean if necessary.
● Check the wings of the mowing blade
for damage or wear and replace if
necessary.
Emptying the grass catcher box
● Disengage the mowing deck. (
The continuous tone ceases.
● Select the highest mowing deck cutting
level. (
8.11)
● Drive the machine to the point at which
the clippings are to be emptied.
● Pull out the grass catcher box emptying
lever and push it forward. (
Grass catcher box swings upwards and
the clippings fall out.
● With the grass catcher box raised, it
may be necessary to drive forward
slightly, so that the clippings can fall out
of the grass catcher box.
● Briefly swing the grass catcher box up
and down so that the all the clippings
fall out.
● Slowly move the grass catcher box
emptying lever towards the rear and
allow the grass catcher box to re-
engage with the rear panel.
● Release the grass catcher box
emptying lever again and press down
until it has returned to the initial
retracted position.
12.10 Removing and attaching the
grass catcher box
Before removing:
● Disengage the mowing deck. (
● Empty the grass catcher box. (
● Engage the parking brake. (
● Stop the engine. (
12.3)
0478 193 9905 B - EN
8.3)
8.12)
8.3)
12.9)
8.10)
Publicidad
