Publicidad
Idiomas disponibles
Idiomas disponibles
18 8. Settings
8. Settings
8.1 Performing settings
- The instrument is switched on.
1 Open settings mode with [
- A box appears around the selected function.
2 Select the required function with [
3 Perform settings with [
Functions
Backlight: set the intensity of the display illumination.
Laser: switch the laser on/off for measurement spot marking.
Beeper: switch the beeper on/off.
Continual: switch continual IR measurement on/off.
Unit: set the temperature unit.
Emissivity: set the emission level (also see chapter 8.2). This function can also be opened directly from
the measurement view with
Memory: manage the memory (also see chapter 8.3).
Alarm: set alarm thresholds (also see chapter 8.4).
Calendar: set the date and time. When measurement data is saved, it is given a date and time stamp.
Language: set the user interface language (also see chapter 6.2).
Reset: reset to factory settings.
Information: display instrument information.
8.2 Details: Emissivity
The emission level can be set in three different ways.
- The
Emissivity function is opened.
Select material
Select a material (with allocated typical emission level) from the list with [
apply the selection with [
Customise manual
1 Use [
] to select Customise manual and open the function with [
2 Set the emission level with [
Customise automatic
A connected contact probe or a separate contact thermometer is required. The
emission level is calculated via a comparison of the measured surface temperatures
(contact measurement and IR measurement).
If the temperature differential between the measurement object and the surrounding
environment is too low, an automatic calculation is not possible (display: - - -) and the
previously set value is retained.
1 Use [
] to select Customise automatic and open the function with [
- If a contact probe (thermocouple type K, class 1) is connected, the surface
temperature measured via the thermocouple (T
connected, the temperature (measured with a different contact thermometer) must
be entered with [
2 Apply the measured or selected value with [
].
] and open with [
] and apply with [
ε
[
]
.
].
] and apply this setting with [
].
].
]:
].
) is displayed. If no contact probe is
TC
].
] and
].
].
Publicidad
