HSM Powerline 450.2 Instrucciones De Servicio página 10

english
6 Troubleshooting
Paper jam
You have fed in too much paper.
 Document shredder blocked.
 Red LED on the keypad fl ashes.
 The motor automatically runs in reverse
for several seconds.
Caution!
Do not alternately press the "On" and
"Reverse" buttons to remove the blockage.
This will damage the document shredder.
CAUTION!
The blade rollers can still cause injuries
even while they are not running. Do not
reach into the cutting unit!
• Open the fl ap and remove the paper.
If not all of the material was ejected:
• Close the fl ap again.
• Press the reverse button.
 Cutting unit runs in reverse.
• Remove the paper.
• Take half the stack of paper.
• Feed in the paper in sheet at a time.
Electric motor overheated
 The indicator on the control panel comes
on in red.
 The document shredder switches off .
• Let the document shredder cool down
for approx. 15 - 20 minutes.
10
Front door or fl ap open
 The red LED on the keypad illuminates.
 The document shredder switches off .
• Close door and fl ap.
• The catch bolt has not engaged.
Note If the door or the fl ap is opened while the
cutting unit is running, the document shred-
der must be restarted using the green but-
ton after the door of the document shredder
has been closed.
Waste bag full
 The red LED on the keypad illuminates.
 The document shredder switches off .
Note Reversing the cutting unit is also possible
even when the waste container is full.
• Change the waste bag.
Caution!
Empty the full waste bag immediately,
since cutting unit malfunctions can occur
because of the pressure from additional
shredded material.
HSM Powerline 450.2
05/2022