Worx WX641 Manual De Instrucciones página 10

This tool may cause hand-arm vibration syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of exposure level in the actual conditions of use should
also take account of all parts of the operating cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration and noise accessories.
Plan your work schedule to spread any high vibration tool use across a number of days.
ACCESSORIES
Paper hole punch
dust box
32mm dust extraction adaptor
35mm dust extraction adaptor
60 grit clamp sanding paper
10
80 grit clamp sanding paper
120 grit clamp sanding paper
If using sanding paper without dust holes, you must use the paper punch to make holes.
Use 1/3 sheet sanding paper of the following size:
Sanding Paper size:
93*230mm for no hook & loop (Clamp only)
93*182mm for hook & loop
We recommend that you purchase your accessories listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for further details. Store personnel can assist you and offer
advice.
Finishing Sander
WX641 WX641.1
1
1
1
1
2
2
2
WX642 WX642.1
1
1
1
1
3
3
3
EN