Battery
WARNING
Battery posts, terminals and related
accessories contain lead and lead compounds - chemicals
known to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
The installer must supply and install a starting battery that
conforms to the specifications listed below.
Battery Specifications
Volts
12 Volt DC
Amps (MIN)
775 CCA (cold cranking amps)
Type
AGM (Absorbent Glass Mat)
Terminal
Post
Hardware
Dimensions
(MAX):
Width
7.5 inches (191 mm)
Length
11.25 inches (286 mm)
Height
10.0 inches (254 mm)
Install the battery as described under Servicing the
Battery in the Maintenance section. Always make sure the
NEGATIVE cable is connected last.
WARNING
Storage batteries give off explosive hydrogen
gas during recharging.
Slightest spark will ignite hydrogen
and cause explosion, resulting in death, serious injury and/
or property damage. Battery electrolyte fluid contains acid
and is extremely caustic. Contact with battery contents
could cause severe chemical burns. A battery presents a
risk of electrical shock and high short circuit current.
• DO NOT dispose of battery in a fire. Recycle battery.
• DO NOT allow any open flame, spark, heat, or lit
cigarette during and for several minutes after charging
a battery.
• DO NOT open or mutilate the battery.
• Wear protective goggles, rubber apron, rubber boots
and rubber gloves.
• Remove watches, rings, or other metal objects.
• Use tools having insulated handles.
Final Installation Considerations
Installation Inspection
Before placing the generator system into service, review the
instructions while carefully inspecting the entire installation
to ensure the installation is complete and correct.
Fuel Supply System
Ensure that all fuel pipe connections are tight, secure, and
without leaks. Ensure that all gas line shutoff valves are
OPEN and that adequate fuel pressure is available.
21