Monogram PVM1790 Instrucciones De Instalación página 12

A
OUTSIDE TOP EXHAUST
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Install Adaptor
A4. Mount Oven
A5. Adjust Exhaust Adaptor
A6. Connect Ductwork
A1
ATTACH THE MOUNTING PLATE
TO THE WALL
A
C
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud. Recommended locations on the mounting
plate are indicated by A, B, C and D.
1
Remove the toggle wings from the bolts.
2
Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach
the toggle wings to 3 ⁄
Installation Instructions
B
D
" onto each bolt.
4
(Vertical Duct)
To use toggle bolts:
Mounting
Plate
Place the mounting plate against the wall and insert
3
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under
the cabinet.
CAUTION:
pinching fingers between the back of the mounting
plate and the wall.
4
Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
12
Spacing for Toggles
More Than Wall
Thickness
Toggle Wings
Toggle
Bolt
Wall
Bolt End
Be careful to avoid