Monogram PVM1790 Instrucciones De Instalación página 16

To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
3 Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under
the cabinet.
CAUTION:
fingers between the back of the mounting plate and
the wall.
4 Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
USE TOP CABINET TEMPLATE
B3
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION:
drilling holes in the cabinet bottom.
Installation Instructions
Bolt End
Be careful to avoid pinching
Wear safety goggles when
B4 ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
1 Remove the three screws that hold the blower
plate to the oven. Slide blower plate from under
its retaining flange. Remove and save the screw
that holds blower motor to oven.
Retaining
Flange
2 Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
BEFORE: Fan Blade
Openings Facing Up
End A
3 Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Oven
4 Gently remove the wires from the grooves.
Reroute the wires through grooves on other side
of the blower unit.
Before Rerouting
Wires Routed Through Right Side
16
Blower Plate
Blower Motor
Screw
End B
After Rotation
Back of
Oven
After Rerouting
Wires Routed Through Left Side