C4
MOUNT THE OVEN
5
Insert 2 self-aligning screws
(
1
⁄
"-28 x 3
4
top cabinet holes. Turn two full
turns on each screw.
NOTE: Use self-aligning screw,
PVM1790 and self-aligning screws,
on PSA1200 and PSA2200.
7
Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet.)
8
Install grease filters. See the Owner's Manual
packed with the oven.
Installation Instructions
(continued)
1
⁄
") through outer
4
6
Tighten center
screw completely.
1
⁄
"-28 x 2
5
⁄
", on
4
8
1
⁄
"-28 x 3
1
⁄
4
4
C5
INSTALLING THE CHARCOAL
FILTER
1
Remove 2 screws on top of oven, just above
the grille panel, using a Phillips screwdriver.
2
Open the door.
3
Remove the grille.
Grille
4
Insert the filter into the oven as shown until it fits
",
squarely into place. It will rest at an angle behind
the front lower tabs. When properly installed,
the wire mesh of the filter should be visible
from the front.
5
Replace the grille and the 2 top screws.
6
Close the door and replace left side screw.
22
Screws
Charcoal filter
Charcoal filter installed
Front lower tabs