Honeywell Miller MightyLite+ MML-OGC1 20FT Manual Del Usuario página 11

Step 2: On the MightEvac bracket, insert
only the top pin.
Step 3: Holding the MightEvac unit by
the handle on the back and making sure
the inserted pin is on the top half of the
bracket, hang the MightEvac onto the
DuraHoist bracket.
Step 4: Secure by inserting the second pin
through the bottom hole sets of both the
DuraHoist and the MightEvac brackets.
To remove the device, simply reverse the
installation procedure.
Installation to DuraHoist Davit Arm
Step 1: Install DuraHoist mounting bracket
DH-AP-11 to davit arm per DuraHoist
Instructions.
Step 2: Follow steps 2 through 4 above to
secure MightEvac bracket to DuraHoist
bracket.
To remove the device, simply reverse the
installation procedure.
4.9 Installation Procedure to Davit
System
Step 1: Place bracket hook over Davit System,
align the top holes of the bracket with the hole
of the Davit System and insert pin completely
through bracket with Davit System.
Step 2: Align the bottom holes of the
bracket with the holes in the Davit System.
Insert the pin completely through the
bracket and the Davit System.
To remove the device, simply reverse the
installation procedure.
4.10 Installation Procedure to
Quad Pod
(See Fig. M & N)
Step 1: Place bracket over tubing of Quad
Pod and align the bottom holes of the
bracket with the desired holes in the tubing
of the Quad Pod. Insert pin completely
through both the bracket and tubing of
the Quad Pod.
Insert pin completely through both the
bracket and tubing of the Quad Pod.
Step 2: Push pin through the top holes
of the bracket passing behind the tubing
of the Quad Pod. Make sure pin goes
completely through both sides of the
bracket.
To remove the device, simply reverse the
installation procedure.
4.11 Installation Procedure to Wall
Mount
(See Fig. O)
Step 1: Place bracket over tubing of Wall
Mount, align the bottom holes of the
bracket with the desired hole in the Wall
Mount and insert pin completely through
both the bracket and tubing of the Wall
Mount.
Step 2: Push pin through the top holes
of the bracket passing behind the tubing
of the Wall Mount. Make sure pin goes
completely through both sides of the
bracket.
To remove the device, simply reverse the
installation procedure.
5.0 Operation
5.1 Retrieval Operation
FOR EMERGENCY USE ONLY
The MightEvac retrieval mechanism is to
be used only in the event of an emergency.
Do not use for routine hoisting of personnel
or materials.
NOTE: It is recommended to pull out
several feet of lifeline and hold in position
before engaging retrieval mechanism.
Always maintain tension on the lifeline
while in retrieval mode.
Pull out on the plunger pin until the ratchet
handle pops outward. It may be necessary
to rotate the handle slightly to fully engage
the internal gears. The plunger pin should
snap back into its original position when
the gears are fully engaged. The unit is
now in retrieval mode.
NOTE: A rescue may be executed either by
raising or lowering a person to safety.
TO RAISE: While maintaining light tension
on the lifeline, rotate the ratchet handle
counter-clockwise (CCW) to crank the
lifeline into the housing.
TO LOWER: To extend lifeline from the
housing (to lower), rotate ratchet handle in
clockwise (CW) direction.
NOTE: If the internal braking mechanism
has been activated, such as with a fall
arrest, it is necessary to first crank in the
counter clockwise (CCW) for one-half to
one rotation, then reverse the direction
(CW) to begin lowering. A minimum of 75
lb (34kg) is required for lowering.
11