Delta ShopMaster S26-271L Manual De Instrucciones página 10

ATTACHING WORK CLAMP
The horizontal work clamp secures the workpiece to the
fence to provide more stability and keeps the workpiece
from creeping toward the saw blade.
To install the horizontal work clamp, see Figure 6 and do
the following:
1. Place the clamp shaft (A) in either hole (B) on the
miter table base.
2. Rotate the knob (C) on the clamp clockwise to move
it in or counter clockwise to move it out as needed.
INSTALL DUST COLLECTION BAG
The tool includes a dust collection bag that attaches over
the exhaust port on the upper blade guard. See Figure 7,
then:
1. Squeeze the two metal clips (D) at the mouth of the
bag.
2. Slide the clips over the dust port (E) until the metal
ring in the bag locks between the grooves on the
exhaust port.
NOTE: To remove the dust bag for emptying, simply
reverse the above procedure.
ASSEMBLY
10
B
FIGURE 6
D
E
FIGURE 7
C
A