AEG KMK761080B Manual De Instrucciones página 77

12.1 What to do if...
The appliance does not turn on or does not heat up
Possible cause
The appliance is not connected to an electrical supply
or it is connected incorrectly.
The clock is not set.
The door is not closed correctly.
The fuse is blown.
The appliance Child Lock is on.
Components
Description
The lamp is burnt out.
12.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
F240, F439 - the touch fields on the display do not
work properly.
F908 - the appliance system cannot connect with the
control panel.
When one of these error messages continues to appear on the display, it means a faulty
subsystem may have been disabled. In such a case contact your dealer or an Authorized
Service Centre. If one of these errors occurs, the rest of the appliance functions will continue to
work as usually.
Code and description
F131 - the temperature of magnetron sensor is too
high.
Remedy
Check if the appliance is correctly connected to the
electrical supply.
Set the clock, for details refer to Clock functions chap‐
ter, How to set: Clock functions.
Fully close the door.
Make sure the fuse is the cause of the problem. If the
problem recurs, contact a qualified electrician.
Refer to "Menu" chapter, Submenu for: Options.
Remedy
Replace the lamp, for details refer to "Care and Clean‐
ing" chapter, How to replace: Lamp.
Remedy
Clean the surface of the display. Make sure there is no
dirt on the touch fields.
Turn the appliance off and on.
Remedy
Turn the appliance off and wait until it cools down. Turn
the appliance on again.
ENGLISH 77