Skil SB2001C-00 Manual Del Propietário página 14

Installing the Chute (Fig . 5)
WARNING
discharge chute in place.
1. Align the three holes in the chute with three
rods on the chute base and push the chute
down.
2. Align the three holes in the front chute-
rotation handle with the holes in the chute
and place the handle onto the chute.
3. Use a Phillips screwdriver (not included) to
secure the chute in place with three long
bolts.
Installing the Remote Chute-rotation Handle (Fig . 6a, 6b, 6c, 6d)
1. Rotate the front chute-rotation handle to make sure the chute discharge opening is facing
straight ahead (Fig. 6a).
2. Thread the short end of the chute-rotation shaft through the hole in the supporting seat as
shown in Fig. 6b.
3. Install the left and right halves of the grip handle onto the shaft. Align the holes in both
halves of the grip handle. Use a Phillips screwdriver (not included) to securely fasten the
left and right halves of the grip handle to the shaft with six screws (Fig. 6c).
4. Make sure that the grip handle is facing upward as shown in Fig. 6c.
5. Insert the head of the handle onto the head of the universal joint located under the battery-
compartment cover as far as it will go (Fig. 6d).
6. Insert the R-pin through the hole in the shaft until it snaps into place as shown in Fig. 6e.
WARNING
operator's controls.
Fig . 6a Front Chute-rotation
Handle
14
Never operate the snow
blower without the complete
Turn the remote chute-rotation handle to make sure that the chute rotates
freely and the discharge opening never points toward the operator or
Fig . 5
Front Chute-
rotation Handle
Fig . 6b
Short End
Chute-rotation Shaft
Long Bolt
Chute
Chute Base