Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Tips
Never use a snow blower on frozen lakes, rivers, or similar surfaces .
DANGER
Death or serious injury could occur if the ice breaks.
Never use the snow blower on a rooftop or other unstable surface,
DANGER
which can result in death or serious personal injury .
WARNING
WARNING
WARNING
WARNING
WARNING
snow blower in any direction and cause serious personal injury to the operator and
others .
WARNING
pack is installed . Always ensure all moving parts have stopped and the battery pack
has been removed before clearing any obstructions . Failure to follow these instructions
can result in serious personal injury.
If the snow blower comes in contact with any type of obstruction or debris during use, stop
•
the snow blower, remove the battery pack, remove the obstruction, and inspect the unit
carefully for damage before proceeding.
Take notice of the direction of the wind before beginning. When possible, discharge snow in
•
the same direction as the wind to prevent snow from being thrown back into your face.
Some parts of the snow blower can freeze under extreme weather conditions. Do not
•
attempt to operate the unit with frozen parts.
When finished, allow the motor to run for an additional few minutes to prevent moving parts
•
from freezing, then turn the remote or front chute-rotation handle lef and right several times
to free the chute from any ice buildup. Make sure to clean off any snow and ice from the
chute base.
In snowy and cold conditions, some controls and moving parts may freeze. Do not use
•
excessive force when trying to operate frozen controls. If you have difficulty operating any
control or part, start the snow blower as instructed in the chapter "Starting/Stopping the
Snow Blower" and let it run for a few minutes.
Snow Blower Overload Protection
To prevent overload conditions, do not try to remove too much snow at a time. Slow down your
pace or decrease the width of the snow-clearing swath.
Your snow blower has built-in overload-sensing elements. When the snow blower is
overloaded, the motor will decrease the speed automatically and you will hear a decrease of
motor noise. Slow down your pace or narrow the clearing width in this case, after which the
motor speed will resume its normal operation automatically. If this remedy does not solve the
overload situation, the sensor will shut off the motor automatically. Remove the battery pack
from the snow blower. Check to see if there is snow or ice stuck in the auger and deck, and
use a clean-out tool to clear them out as necessary. Reattach the battery pack and restart the
snow blower.
20
Do not use snow blower on ice, which can cause the operator to slip
and fall, resulting in possibly serious personal injury .
Do not wear loose clothing, scarves, or jewelry . They can be caught in
moving parts and cause death or serious personal injury.
Keep all snow discharge pointed away from all electrical devices to
reduce the risk of electrocution or electric shock .
Never point the snow blower or discharge chute in the direction of people
or pets . Thrown snow or other objects can cause serious personal injuries.
Make sure that the area to be cleared is free of stones, sticks, wires,
gravel, and other objects that could be accidentally thrown by the
Never reach into the discharge chute or place any body part in front
of the snow blower when the unit is operating or when the battery
Publicidad
