Garland XTRIM 900 PG Manual De Instrucciones página 30

English
6. START UP INSTRUCTIONS
6.1. LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Engine.
• Transmission.
• Protector.
• Handle.
• Harness.
• Tooling.
• Instruction manual.
Ensure that all elements listed above are included
with the machine. Thanks to the quality control checks
at the factory it is highly unlikely that any elements
will be missing. If you were to find any element
missing, do not use the machine until the defect has
been repaired or the machine is complete.
Using the machine with defective parts or without
all the elements can cause severe personal
damages.
6.2. MOUNTING THE MACHINE
6.2.1. INSTALLATION OF THE HANDLEBAR
Install the handlebar on the upper transmission bar
as shown in the figure, placing it at the distance from
the throttle control that is most comfortable for you
to work with the machine. Tighten the 4 handlebar
clamp bolts firmly to prevent the handlebar from
moving.
6.2.2 GUARD SUPPORT ASSEMBLY
Position the protector as shown in the figure.
Insert a lock washer and a flat washer into the
hexagon head screws, screw on both sides. Then
insert a flat washer on the star head screws and
screw in the center.
6.2.3. INSTALLATION OF THE TRANSMISSION
6.2.4. ASSEMBLY AND DISASSEMBLY OF THE 2-WIRE
HEAD
To mount the head insert the head onto the shaft and
then screw it clockwise. To prevent the shaft from
30/124