Publicidad
Idiomas disponibles
Idiomas disponibles
6.5. POINTS TO BE VERIFIED AFTER MACHINE
STARTS
It is neccesary to pay attention to posible loosening
or overheating of parts of the machine. If you detect
any anomalies stop inmediatly the machine and check
it carefully. In case of failure take the machine to
the repair service. In any case you should continue
working if you feel that the performance is not correct.
Do not use the machine if it is damaged or
incorrectly regulated.
After starting up and the engine is hot, the cutting
tool must not be moved if the engine is idle. If the
cutting tool turns with the engine running and without
accelerating, it will be necessary to regulate the idling
regime of the engine. To do this, turn the carburetor
nut until the engine stops.
If you are unable to regulate the idling regime to stop
the cutting tool, because the engine stalls, please
contact the customer service for help.
The regulation of the screws (H) and (L) must only
be carried out by an official technical servicer.
7. MACHINE USAGE
Only use this machine for those jobs for which
it has been designed. The use of this brush cutter for
other uses is dangerous and could cause damages to
the user and/or the machine.
Do not bring any cutting elements near when
the machine is in use and the engine running.
Do not rely solely on the warning signs on the
machine. Be always alert.
Do not use the machine if you are feeling
tired, unwell or under the effects of
medication, intoxicating substances or
alcohol.
Lack of sleep and fatigue can cause accidents and
damages. Limit the usage time of the machine to 10
minutes and rest a further 10 to 20 minutes between
working sessions.
It is neccesary to pay attention to posible loosening
or overheating of parts of the machine. If you detect
any anomalies stop inmediatly the machine and check
it carefully. In case of failure take the machine to
the repair service. In any case you should continue
working if you feel that the performance is not correct.
Remember to always use the machine with clean
hands and without petrol and oil. Be particularly
attentive if you use the machine under the rain as the
ground will be slippery.
If you slip or fall stop accelerating and move the
switch to
"0" (Off).
Clean the work area and eliminate any obstacles
that could cause accidents. Check the area to be cut
and remove any objects that could cause the nylon
head of the machine to get tangled on. Also remove
any parts that the disc could violently hit causing these
to move in the direction of the user or other people
and/or animals.
Do not allow any other person into the work area.
All other people must be at least at a distance of 15
metres as it is a dangerous area.
Do not use this machine at night, with fog and with
reduced visibility. Always make sure that you can
clearly see all the working area.
33/124
English
Publicidad
