ALPHA-TOOLS A-DF 900 Manual De Instrucciones Original página 11

Anleitung_A_DF_900_SPK7:_
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
1. Handle
Vibration emission value a = 5,252 m/s 2
h
K uncertainty = 1,5 m/s
2
2. Additional handle
Vibration emission value a ≤ 2,5 m/s 2
h
K uncertainty = 1,5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
24.02.2012 10:10 Uhr
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
88 dB(A)
1. Lung damage if no suitable protective dust mask
3 dB is used.
2. Damage to hearing if no suitable ear protection is
99 dB(A)
used.
3 dB
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
6. Before starting the machine
Before you connect the machine to the mains sup
ply make sure that the data on the model plate
are identical to the mains data.
The adapter for the dust extraction system (5) and
the dust bag (2) must be fitted (Fig. 2).
7. Operation
7.1 Setting the cutting depth (Fig. 3)
Set the required cutting depth with the setting
wheel (3).
The designations on the setting wheel reflect the
various sizes of biscuit dowels
Push the drive motor (11) forwards to check the
cutting depth. The plug must be disconnected
from the mains supply for this purpose.
You can adjust the cutting depth setting using the
screw (a).
7.2 Setting the cutting angle and cutting height
(Fig. 4)
Undo the two star grips for the angle adjustment (2)
and height adjustment (12).
Important! The set angle is indicated by the arrow
(b).
You can infinitely adjust the angle stop (10) to the
required angle between 0° and 90°.
Set the required height (17) on the height scale (a);
the height of the groove should always be in the
center of the workpiece.
Now retighten the two star grips.
A single pass will suffice for thin workpieces.
Several passes over the workpiece are required for
thicker workpieces.
Seite 11
GB
11