BD Veritor Plus Analyzer Instrucciones De Uso página 29

BD Veritor™ Plus Analyzer Instructions for Use
If the BD Veritor InfoSync Module is installed, the following additional information is provided on a second screen:
• InfoSync Module serial number
• Data subscription expiration date
• Module firmware version
• Module cellular identification numbers
The display window will continuously cycle between the first and second screens every 5 seconds.
To enter this mode, scan the following barcode during the workflow configuration scan step. The display will remain until the Analyzer power
is turned off. See section 4.6–Workflow Configuration for information on the configuration scan step.
Analyzer Information Display
Show system information in the display window.
Barcode Scanner Test Mode
This mode places the BD Veritor InfoScan Module or BD Veritor InfoSync Module barcode scanner into continuous operating mode. Any
barcode presented to the scanner will be read and the value shown in the display window. This mode may be used to verify that the
scanner is functioning correctly by scanning a known barcode, or may be used to confirm that the scanner is able to read the barcodes in
use at a particular facility.
After scanning a barcode, its value will be shown in list form in the display window. Each value has an index number and the display
window will scroll up to show new values. Barcode values longer than a single display line will wrap to the next line. If no barcode is
presented within 30 seconds, the barcode scanner will turn off and a timeout message will appear in the display window. To exit the mode,
turn off the power by depressing the front panel power button for at least half a second and releasing it. If the Analyzer is left unattended for
15 minutes (when operating on the internal battery) or 60 minutes (when operating on the external power adapter), the BD Veritor Plus
Analyzer will automatically shut off and the display content will not be retained.
To enter this mode, scan the following barcode during the workflow configuration scan step. The test mode will remain active until the
Analyzer power is turned off. See section 4.6 – Workflow Configuration for information on the configuration scan step.
Barcode Scanner Test
Show scanned barcode values in the display window.
22
Module S/N: 123456789
Data Expiration: DD-MMM-YYYY
Modem Driver: A.01
IMEI: 123456789
ICCID:
123456789
Display System Information
Barcode Scanner Test