gel-o-mat E LEGANCE 50/II K Instrucciones Para Instalación Y Mantenimiento página 47

First run
HOURS MINUTES
1 2
Date and time
First run
2
Medium 15-20°f
Water hardness
Note: PAY MAXIMUM ATTENTION WHEN ENTERING THE PREVIUOSLY MENTIONED PARAMETERS.
AN INCORRECT CHOICE OF WHAT ABOVE MENTIONED MAY CAUSE DAMAGES TO THE MACHINE.
ONLY QUALIFIED PERSONNEL SHALL CARRY OUT THIS OPERATION.
WARNING! When resetting the circuit board, all menu
0 0
If the machine is equipped with the Regeneration optional, the display afterwards
shows the text:
in French degrees.
Confi rm the selection by pressing key
At the end of the programming, the PCB reboots and the machine enters in
by mode.
Water hardness. The default value of the water hardness is indicated
15 parameters are canceled as well.
Start F.
EN
Stand-
page 47