Publicidad
Idiomas disponibles
Idiomas disponibles
EN
6. SIGNALS AND ALARMS
6.1 Signals
The signal messages are displayed, based upon their meaning. They do not block the machine. The signals
remain visible until the operator executes the necessary actions.
Signals with machine in stand-by mode:
When
PRESS WATER SOFTENER REGENERATION KEY
needed (only on machines equipped with the optional Water Softner).
When
SELF-CLEANING: REMOVE FILTERS AND PRESS START
start a Self-cleaning cycle.
When
SELF-CLEANING CYCLE OVER
Signals with machine switch on:
When
DETERGENT LEVEL
the optional "Chemicals level Sensor").
When
RINSE-AID LEVEL
optional "Chemicals level Sensor").
When
SALT LEVEL
appears on the display it means that the salt level in the bowl is low (only on machines equipped with
the optional Water Softner).
When
DOOR OPEN
appears on the display it means that you are trying an operation that cannot be done with the open door.
When
DRAIN WATER IN WASH TANK
done with the wash tank full.
When
WATER PROBE FAIL
disconnected (only on machines equipped with the optional "Loading water probe").
When
FLOWMETER FAIL
on machines equipped with the optional "Flowmeter").
6.2 Alarms
The alarms are displayed, based upon their meaning.
By pressing the key
E
the current alarm information is displayed.
TYPE OF ALARM
B1
B2
B3
B4
B5
B8
B9
E1
E2
E3
E5
E6
E8
Z4
Z5
Z6
Z9
Z10
Y1
table 2
page 48
appears on the display it means that the machine has ended the Self-cleaning cycle.
appears on the display it means that the detergent is over (only on machines equipped with
appears on the display it means that the rinse aid is over (only on machines equipped with the
appears on the display it means that you are trying an operation that cannot be
appears on the display it means that the inlet water temperature probe is damage or is
appears on the display it means that the water fl owmeter is not connected or is disabled (only
CAUSE
BOILER FILLING FAIL
BOILER PROBE FAIL.
BOILER HEAT. ALARM
RINSING FAILED
BOILER OVERHEATING
BOILER PRESSURE SWITCH
BOILER SAFETY THERMOSTAT
WATER LOAD FAILED
TANK PROBE FAIL.
TANK HEATING ALARM
TANK OVERHEATING
TANK DRAINING FAIL.
TANK SAFETY THERMOSTAT
TANK SENSOR FAILURE
TANK HIGH LEVEL
TANK LOW LEVEL
REGENERATION FAIL
ALARM SL8
WATER LOSS
appears on the display it means that a total regeneration is
appears on the display it means that it is suggested to
Publicidad
