EUFY RoboVac Manual Del Propietário página 15

English
Problems Solutions
The rolling brush • Clean the rolling brush.
does not rotate. • Check if the rolling brush and brush guard have been installed properly.
RoboVac's
• Clean the sensors carefully with a dry cloth.
movements or
travel path are • Restart RoboVac by turning the power switch off and on.
abnormal.
Error Tones
When RoboVac is in trouble, it will emit a series of short or long beeps and the red indicator
on RoboVac will be solid or flashing.
Flashing red indicator light
Error Tone Cause
RoboVac is stuck and one of the
One beep wheels is not making contact
with the floor (hanging in mid-air).
Two beeps RoboVac's bumper is stuck.
RoboVac can get stuck in the
following scenarios:
• When RoboVac does not have
enough power to reverse when
on the edge of a staircase that is
covered by a rug.
• When RoboVac tries to
reverse due to exposure to
Three beeps
strong sunshine, but cannot
reverse due to physical
barriers in the way.
• When RoboVac reverses
due to exposure to strong
sunshine, but continues to be
exposed to strong sunshine
after reversing for 3 seconds.
Four beeps RoboVac's power level is too low.
Solid red indicator light
Error Tone Cause
RoboVac's left/right wheel
One beep
is stuck.
RoboVac's side brush is
Two beeps
stuck.
26
Solution
Restart cleaning in a new location.
Tap RoboVac's bumper several times to
dislodge any debris that may be trapped
underneath.
• Clean the drop sensors gently with
a dry cloth.
• Place RoboVac in a new location.
• Use a physical barrier to block off
the problem area.
Manually charge RoboVac for at least
5 hours.
Solution
Turn off RoboVac and remove any hair or
debris from the left/right wheel.
Turn off RoboVac and remove any hair or
debris from the side brush.
Error Tone Cause
RoboVac's suction fan is
Three beeps
stuck.
RoboVac's rolling brush is
Four beeps
stuck.
Specifications
Input
Battery Voltage
Power Consumption
Battery Type
Dust Collector Capacity
Cleaning Time
Charging Time
Charging Temperature
Storage Temperature
Input
Output
English
Solution
• Turn off RoboVac, then remove and
empty the dust collector.
• Make sure the suction inlet is not
blocked by any hair or debris.
Turn off RoboVac and remove any hair or
debris from the rolling brush.
19 V 0.6 A
DC 14.4 V
25 W
DC 14.4 V
Li-ion 2600 mAh
0.6 L
Max. 100 mins
300 - 360 mins
5°C - 40°C
-20°C - 60°C
19 V 0.6 A
19 V 0.6 A
27