Tabla de contenido
Publicidad
MEDIO - GRANDE
EN
USING THE APPLIANCE
6.2
OPERATION AND PROGRAMMING
1
SWITCHING ON
Turn On the main switch on the control panel; the LED in the switch lights up; the display shows the initials of the options available for three
seconds; this is followed by display of the program number set in the top quadrant and eventual functions activated in the bottom quadrant.
2
PROGRAM SELECTION: Select the program (from 0 to 9) using arrows
3
PROGRAMMING THE VAC FUNCTION Enter the programming by pressing
the VAC function LED starts flashing. Set the required value using arrows
4
PROGRAMMING THE SEAL FUNCTION Select the
and confirm by pressing
5
STARTING THE WORK CYCLE: Lower the lid with both hands pressing slightly on the corners. The appliance will start the work cycle according
to the programmed parameters.
6
WORK CYCLE END: The appliance ends the cycle automatically after the sealing bar cooling, with air re-entering the chamber resulting in ope-
ning of the lid. Remove the packed product and check the bag seal: it must be uniform, clearly marked without melted points.If necessary, adjust
the preset values and proceed with the second cycle.
The work cycle can be interrupted at any moment by pressing
also be interrupted by means of the main switch; the cycle is interrupted but air does not re-enter the suction cup: the lid therefore remains closed.
When the machine is switched on again, the cycle is reset, air returns to the chamber and the lid opens.
Operating and service manual / Mode d'emploi et d'entretien
Manual de uso y mantenimiento / Ed. 01 - 2011
function; the relative LED starts flashing. Set the required value using arrows
.
INTERRUPTING THE WORK CYCLE
: interruption is immediate with air re-entering the chamber. The work cycle can
26
.
: the program number starts flashing. Select the
and confirm by means of
VACUUM PACKING MACHINE
CONDITIONNEUSE SOUS VIDE
MAQUINA DE VACÍO
: function;
.
REV. 00 - Cod.: 1500386
Publicidad
Tabla de contenido
