Hd Radio Operations - Clarion NX500 Manual De Instrucciones Y De Instalación

HD Radio Operations

This function is available when an HD Radio tuner is connected.
This unit can control the following HD Radio tuner:
• HD Radio Module (THD400)
Note:
• Be sure to disconnect power before connecting/disconnecting the HD Radio tuner.
• Not all areas offer HD Radio broadcasts
• HD Radio stations may not always broadcast subchannels
• Volume levels of HD Radio stations may vary. Increase the volume gradually from the minimal
setting after the channel is selected. Be sure to lower the volume setting before switching to
another mode or channel.
Additional information about HD Radio can be found at www.hdradio.com
Listening to HD Radio
1. Touch the Tuner button on the Main menu
display. The tuner mode screen is displayed.
2. Press the [BAND] button or touch the [Band]
key on remote control to select the radio
band. Each time the button is pressed, the
radio reception band changes in the following
order: FM1, FM2, FM, AM, FM1...

2
11
20
19
14
18 15 16 17
1 - Stereo indicator
2 - Signal strength
 - Station name
4 - HD Radio status
5 - Clock
6 - Main Menu key
7 - Preset list
8 - EQ mode key
9 - Next preset page
10 - Previous preset page
11 - Frequency display
5 6
1 4
1 12 10
9 8
12 - Seek up
1 - iTunes TAG key
14 - Manual tune up
15 - Auto store/Preset
scan key
16 - Channel scan
17 - HD Radio
subchannel key
18 - Manual tune down
19 - Band key
20 - Seek down
Seek Tuning
1. Press the [BAND] button to select the radio
band (FM or AM).
2. Touch the [
automatically seek a station.
• When touching the [
sought in the direction of higher frequencies.
• When touching the [
sought in the direction of lower frequencies.
Manual Tuning
1. Press the [BAND] button to select the radio
band (FM or AM).
2. Touch the [
automatically seek a station.
• When touching the [
7
sought in the direction of higher frequencies.
• When touching the [
sought in the direction of lower frequencies.
. To quick tune, touch and hold the [
[ ] key to tune into a station.
Recalling a preset station
There are 2 ways to recall the preset station.
• Preset scan function:
1. Press the [BAND] button to select the
desire band (FM or AM) on the remote
control.
2. Press the [AS/PS] key momentarily. The
unit will begin to scan the saved presets.
. When the desired preset is found, press
the [AS/PS] key momentarily.
] or [ ] key to
] key, the station is
] key, the station is
] or [ ] key to
] key, the station is
] key, the station is
NX500/NZ500
] or
47