INSTALLATION /WIRE
CONNECTION GUIDE
CONTENTS
1. Before Starting .................................................................... 55
1. Before Starting
1. This set is exclusively for use in cars with a
negative ground 12V power supply.
2. Read these instructions carefully.
. Be sure to disconnect the battery" "terminal
before starting. This is to prevent short circuits
during installation. (Figure 1)
2. Package Contents
Main unit .................................... 1
Wiring harness ........................... 1
AV cable .................................... 1
USB extension cable ................. 1
Remote control unit ................... 1
Battery (CR2025) ....................... 1
(Installed in remote control)
2DIN trim ring ........................... 1
3. General Cautions
1. Do not open the case. There are no
user- serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
2DIN trim ring 200mm wide ...... 1
Back Strap ................................. 1
Flush mount bolts ..................... 4
Cap bolts ................................... 4
Rear radio stud and stopper .... 1
Cleaning cloth ........................... 1
Warranty Card ........................... 1
Owner's manual and
Installation manual .................... 1
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, or alcohol etc. For tough dirt,
apply a little cold or warm water to a
soft cloth and wipe off the dirt gently.
55
NX500/NZ500