Operations; Basic Operations - Clarion NX500 Manual De Instrucciones Y De Instalación

6. OPERATIONS

Basic Operations

Note:
• Be sure to read this chapter referring to the
chapter ". CONTROLS"
CAUTION
When the unit is turned on, starting and
stopping the engine with its volume raised to
the maximum level may harm your hearings.
Be careful about adjusting the volume.
Turning ON and OFF the Power
Note:
• Start the engine before using this unit.
• Be careful about using this unit for a long
time without running the engine. If you drain
the car's battery too far, you may not be able
to start the engine and this can reduce the
service life of the battery.
1. Start the engine. The power button / knob
illumination on the unit will light up.
2. Press the [ PWR] button on the tuner to
turn ON the power.
. Press the [ ] power button on the remote
control to turn ON the power.
4. To turn OFF the power, press and hold the
[ PWR] power button on the tuner for more
than 2 seconds.
5. To turn OFF the power, press and hold the
[ ] power button on the remote control for
more than 2 seconds.
Engine ON
position
18
NX500/NZ500
Opening and Closing Operational Panel
Press [OPEN] button on the unit (NZ500).
The operational panel will be open.
Press the same button again to close the panel.
CAUTION
• Do not move the operation panel forcibly or
do not apply strong force to the operation
panel.
• When the operation panel is operating, be
careful not to get your hand or finger caught
between the operation panel and main unit
or its mechanical parts.
• The driver should not operate the operation
panel while driving.
Adjusting the Angle of the Operational Panel
Adjust the desired angle by pressing [
tilt buttons on the unit (NZ500).
Selecting a Mode
1. Touch the screen button on the Main Menu to
enter the desired mode: Tuner, Disc, NAVI,
USB, Sirius, AUX IN, AV IN, etc., iPod/iPhone.
*External equipment not connected to this
unit is not displayed.
Turning Monitor ON or OFF
1. Touch the screen button Monitor OFF on the
Main Menu to turn Off the screen.
2. Touch the screen again to turn monitor
screen On.
] [ ]