dormakaba 701 Guia De Instalacion página 4

Boltworks Precautions – Swingbolt Locks
The blocking part "A" of the boltwork should exert force across
the entire width of the lock bolt while opening. When in the
locked position, the boltwork MUST NOT place pressure
on the lock bolt. This could cause the lock to jam.
In case of boltwork construction where two blocking
Note:
parts are moving opposite one another, the one facing the
round side of the lock bolt "B" should be cut off to avoid
jamming of lock bolt.
Lock Case Hole Layout Diagram
Maximum Bolt Load
Deadbolt & Springbolt:
Maximum load movable by the bolt: 5 lbs. (22N)
•
La Gard dead bolt locks may not open if more than 5 lbs. (22N) of force is applied to the end or
Note:
side of the bolt.
Maximum load against bolt when thrown (all directions):
•
Swingbolt:
Maximum load movable by the bolt: None
•
La Gard swing bolt locks may not open if force is applied to the end or side of the bolt.
Note:
Maximum load against bolt when thrown (all directions):
•
Figure 3
dormakaba USA Inc. | Safe Lock Installation Guide 7034.1121 Rev C 07/22
Figure 2
224.8 lbs. (1kN)
224.8 lbs. (1kN)