dormakaba 701 Guia De Instalacion página 8

10. Remove the mounting screw from the system card, and
gently lift the system card out of the case (Figure
11. Insert the spindle through the spindle hole in the front
of the door.
12. With the bolt retracted, carefully thread (clockwise)
the spindle into the drive cam of the lock assembly
until tight.
13. Next, rotate (counterclockwise) at least 1/2 turn
until the groove in the spindle is aligned with
the correct spline position. The correct
spline position for the installation
orientation showing in Figure 10
is RH (for a "Right Hand" door). Refer
to the following Spline Key Position
Chart (Figure 11) for all mounting positions.
14. Insert the spline key fully into the cam from the back of the lock assembly by tapping it into place.
Ensure the spline key is seated against the spindle.
IMPORTANT NOTE:
15. Reinstall the system card.
16. Reconnect the solenoid (and bolt switch if applicable.)
17. Reinstall the back cover.
18. Connect the cable coming from the Entry Device directly into the connector port marked ENT on the lock.
Note: Ensure the cable is secure and away from any moving parts.
10
).
Figure 11
dormakaba USA Inc. | Safe Lock Installation Guide 7034.1121 Rev C 07/22
Figure 10