Stiga MPST 84 Li 48 V1/V2 Manual De Instrucciones página 77

• Remove grass debris and mud accumulated inside the
chassis.
• Always make sure the air intakes are free of debris.
• Do not use aggressive liquids to clean the chassis.
• To reduce the risk of fire, keep the engine free of grass,
leaves residues or excessive grease.
• Lift the hood and clean with compressed air any dirt or
grass residues that accumulate on top of the battery pack.
• Cleaning the cutting means assembly
IMPORTANT Washing the inside of the cutting means as-
sembly and the discharge chute must be performed with the
grass catcher mounted and the mulching cap inserted (if pres-
ent) or with the rear discharge guard mounted.
1. Place the machine on a flat, solid surface.
2. Connect a water hose (fig. 26.A, 27.A) to one of the two
specific couplings and open the water supply.
3. Sit in the driving seat and start the machine.
4. Fully lower the cutting means and engage the cutting
means.
5. Let the water flow for a few minutes and then stop the
machine.
6. Turn off the water supply and disconnect the hose from
the coupling.
7. Repeat the procedure on the other coupling.
8. Blow a jet of compressed air over the upper part of the
assembly (fig. 28).
6.3. CUTTING MEANS MAINTENANCE
Do not touch the cutting means until the ignition
key has been removed and the cutting means is
completely stationary. Be careful that the cutting
means can move, even if the key has been
removed (for battery-powered models).
All work on the cutting means (disassembly,
sharpening, balancing, repairing, reassembly
and/or replacing) are demanding jobs that require
special skills as well as special tools; For safety
reasons, these jobs are best carried out at a
Authorised Service Centre.
Always replace damaged, bent or worn cutting
means, together with their nuts and bolts, in
order to ensure they remain balanced.
IMPORTANT Always use original cutting means bearing the
code indicated in the "Technical Data" table.
7. TRANSPORT, STORAGE AND DIS-
POSAL
7.1. TRANSPORT
When handling the machine, always:
1. disengage the cutting means;
2. bring the cutting means assembly to the highest position;
3. switch off the machine and remove the ignition key
4. disengage the drive (par.4).
When transporting the machine on a vehicle or trailer, always:
• use an access ramp of suitable strength, width and length;
• load the machine with the electric motor switched off, with
the key removed from the ignition, without a driver and
pushed by an adequate number of people;
• lower the cutting means assembly;
• position it so that it does not cause a hazard to anyone;
• engage the drive (par.4);
• lock it firmly on the means of transport using ropes or
chains to prevent it from tipping over and possible damage.
7.2. STORAGE
When the machine needs to be stored, remove the ignition key.
Store the machine:
• with the cutting means assembly lowered
• in a dry place;
• protected against poor weather conditions, at a
recommended temperature of between 0 and +40 °C;
• covered with a sheet if possible;
• in a place out of children's reach;
• making sure that keys or tools used for maintenance are
removed.
NOTE Ensure that the battery is fully charged at least once a
month and always before use.
NOTE Store the machine so as to avoid any risk in the event
of accidental contact with people, children or animals.
EN - 8