Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE LOCATING THE FIXING BRACKETS
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply force onto
the controls protruding from the hob.
LOCATING THE FIXING BRACKETS
Fix the brackets on the left side and right side by screw. Put the induction hob in the cut-out cabinet.
CAUTIONS:
• The hob must be installed by qualified personnel or technicians, we have professionals at your
service. Please never conduct the operation by yourself.
• Do not mount the hob above cooling equipment, dishwashers and dryers.
• The hob shall be installed such that better heat radiation can be ensured to enhance its reliability.
• The wall and induced heating zone above the work surface shall withstand heat.
• To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
• A steam cleaner is not to be used.
• This hob can be connected only to a supply with system impedance no more than 0.427 ohm. In
case necessary, please consult your supply authority for system impedance information.
CONNECTING THE HOB TO THE MAINS POWER SUPPLY
This hob must be connected to the mains power supply only by a suitably qualified person.
Before connecting the hob to the mains power supply, check that:
1. The domestic wiring system is suitable for the power drawn by the hob.
2. The voltage corresponds to the value given in the rating plate.
3. The power supply cable sections can withstand the load specified on the rating plate. To connect
the hob to the mains power supply, do not use adapters, reducers, or branching devices, as they
can cause over heating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its temperature
will not exceed 75℃ at any point.
Check with an electrician whether the domestic wiring system is suitable without
alterations. Any alterations must only be made by a qualified electrician.
61
Publicidad
