COSY ARTEVINO Modo De Empleo página 23

II. Installation
Transport your cabinet to its intended location. The place you choose to install your wine cabinet must:
– be open and well ventilated (not enclosed in a cupboard, for example),
– be away from any source of heat or direct sunlight,
– not be too damp. Max 85% ambient humidity (linen cupboard, laundry room, bathroom...).
Ensure that no water splashes onto the entire back section of the appliance,
– have a flat, stable floor,
– have an accessible standard power supply which does not come into contact with any of the appliance's
components (standard outlet that complies with standards in the country, earthed with circuit breaker). The use
of extension cords or adaptors is forbidden.
Adjust the cabinet's 4 feet (by screwing or unscrewing) in order to level your cabinet (use of a spirit level recommended).
For single-temperature models only:
- If you notice low humidity levels (<55%) a few days after setting
your wine cabinet into operation, we recommend that you use the
humidity cartridge, supplied in a bag with the appliance. Place it at the
bottom of the cabinet, under the rack in the drip tray provided (see
diagram below). When using for the first time, completely immerse
your cartridge in tap water for a few minutes to saturate it then allow
it to dry. Depending on external conditions, it may be necessary to
add a 10cl glass of water after several months.
If you leave your wine cabinet closed for long periods (>3 months) in an environment where the temperature
is close to your cabinet's temperature setting (a difference of about <5°C) this could create an environment in
which mould develops or cause your bottles's labels to peel off. Lack of dehumidification and air renewal can create
significant humidity inside the cabinet. We strongly recommend that you regularly monitor your cabinet and clean
it once a year.
III. Precautions
• Do not place your cabinet in an area liable to flooding.
• Never obstruct the front air vent.
• To facilitate levelling, your wine cabinet is fitted with 4 adjustable feet.
• Carry out the final levelling of your wine cabinet (use of a spirit level recommended).
• N.B.: the LEDs on the control panel must only be replaced by a qualified electrician.
• When moving your cabinet, never tilt it more than 45°, and always on its side (on the opposite side of the flexible lead).
Wait 48 hours before plugging in your appliance.
EN
6