BELLOTA HL1100 Manual Del Usuario página 26

5. Assembly
After unpacking your pressure washer, lay out
the parts and accessories on a flat surface and
familiarize yourself with the parts in the package
by comparing them to those on page 14.
Note: Some parts may or may not already be
assembled.
HL1100
• To assemble the handle, place it on top of the
unit, push down until it clicks into place, insert
the corresponding screws and tighten until the
handle is completely secure.
Slide the gun mount into the slot on the side of
your pressure washer.
To connect the high pressure hose take
one end (A) of it to your pressure washer by
inserting it into the rear left side, push until it
clicks. Confirm that the hose is connected to
your pressure washer by pulling slightly. To
release the hose of your pressure washer press
the button located at the rear and the hose will
slide out.
HL1400
• To assemble the handle, place it on top of the
unit and align the two clips on the handle with
the two holes on the machine (A) and push
back until it clicks.
• To connect the high pressure hose.
Connect one end of the high pressure hose to
the hole in the back of your pressure washer,
press the latch towards the hole and insert the
metal connector of the high pressrure hose.
Release the latch to lock the hose in place (A).
HL1700
Attach the handle to the back of the cleaner by
lining up the holes in the handle with the shafts
on the machine. Slide it on and secure it using
the two supplied screws(A).
(A)
• Attach the storage for the trigger gun and
lance to the right side of the cleaner. Slide it on
and secure it using the supplied screw (B)
22
(A)
(A)
(A)
(Not included)